Diy oil change for nissan murano: a step-by-step guide

Changing the oil in your Nissan Murano is a crucial maintenance task that helps keep your engine running smoothly and efficiently. Whether you’re a seasoned DIY enthusiast or a novice mechanic, this step-by-step guide will provide you with all the information and instructions you need to perform an oil change on your Nissan Murano.

Materials You’ll Need

• New oil filter (check your owner’s manual for the recommended type)
• 5 quarts of 5W-30 synthetic oil
• Oil drain pan
• Funnel
• Wrench
• Rags or shop towels

Safety Precautions

• Park your Nissan Murano on a level surface and engage the parking brake.
• Allow the engine to cool down for at least 30 minutes before starting any work.
• Wear gloves and safety glasses to protect yourself from hot oil and debris.

Step-by-Step Instructions

1. Locate the Oil Drain Plug

• Crawl under the front of the Nissan Murano and locate the oil drain plug. It is typically a 17mm bolt located at the bottom of the oil pan.

2. Place the Oil Drain Pan

• Position the oil drain pan directly under the oil drain plug. Make sure it’s large enough to catch all the used oil.

3. Remove the Oil Drain Plug

• Using a wrench, carefully loosen and remove the oil drain plug. Be cautious as the oil will start to drain out immediately.

4. Drain the Oil

• Allow all the oil to drain into the oil drain pan. This may take several minutes.

5. Replace the Oil Drain Plug

• Once the oil has completely drained, clean the oil drain plug and the threads on the oil pan.
• Apply a small amount of thread sealant to the threads of the oil drain plug and tighten it back into place.

6. Locate the Oil Filter

• Open the hood of the Nissan Murano and locate the oil filter. It is typically a cylindrical-shaped component located near the top of the engine.

7. Remove the Oil Filter

• Using a wrench, carefully loosen and remove the oil filter. Be prepared for some residual oil to spill out.

8. Install the New Oil Filter

• Apply a thin layer of oil to the rubber gasket on the new oil filter.
• Screw the new oil filter onto the engine by hand until it’s snug.
• Use the wrench to tighten the oil filter another 3/4 of a turn.

9. Add New Oil

• Using a funnel, pour 5 quarts of new 5W-30 synthetic oil into the engine.
• Check the oil level on the dipstick to ensure it’s between the “MIN” and “MAX” marks.

10. Check for Leaks

• Start the engine and let it run for a few minutes.
• Check under the Nissan Murano for any oil leaks. If you notice any leaks, tighten the oil drain plug or oil filter as necessary.

Summary: Empowering DIY Oil Changes

By following these steps, you can confidently perform an oil change on your Nissan Murano, saving you time and money while ensuring your engine stays healthy. Remember to refer to your owner’s manual for specific recommendations and precautions for your particular model year.

Frequently Asked Questions

1. How often should I change the oil in my Nissan Murano?

Every 5,000 miles or 6 months, whichever comes first.

2. What type of oil should I use in my Nissan Murano?

5W-30 synthetic oil is recommended.

3. How long does it typically take to change the oil in a Nissan Murano?

Approximately 30-45 minutes if you are following the steps carefully.

4. Can I use a different type of oil filter than the one recommended?

No, it is important to use the oil filter specified in your owner’s manual.

5. What should I do with the used oil?

Dispose of the used oil properly at a recycling center or auto parts store.