No code needed: the secret to resetting your ford flex keyless entry

Losing your Ford Flex keyless entry remote can be a frustrating experience, especially if you don’t have the factory code. But don’t worry, it’s still possible to reset your keyless entry system without the code. Here’s a comprehensive guide to help you navigate the process:

Step 1: Gather Your Tools

Before you begin, you’ll need:

• A Phillips head screwdriver
• A flathead screwdriver
• A new keyless entry remote (optional)

Step 2: Remove the Steering Column Cover

• Turn the steering wheel to the fully extended position.
• Use the Phillips head screwdriver to remove the two screws holding the steering column cover in place.
• Gently pull the cover down and off.

Step 3: Locate the Keyless Entry Module

• Once the steering column cover is removed, you’ll see the keyless entry module. It’s typically a small, black box located behind the steering wheel.

Step 4: Disconnect the Keyless Entry Module

• Use the flathead screwdriver to gently pry the keyless entry module loose from its mounting bracket.
• Be careful not to damage the wires connected to the module.

Step 5: Reset the Keyless Entry Module

• Turn the ignition key to the “On” position.
• Wait for the “Security” light to turn off.
• Press and hold the “Unlock” button on the keyless entry module for 10 seconds.
• Release the button and the “Security” light should flash.
• Repeat steps 5-6 three more times.

Step 6: Reconnect the Keyless Entry Module

• Once the “Security” light has flashed four times, reinsert the keyless entry module into its mounting bracket.
• Secure the module with the screws.

Step 7: Reprogram the Keyless Entry Remote (Optional)

If you have a new keyless entry remote, you’ll need to program it to your vehicle.

• Turn the ignition key to the “On” position.
• Wait for the “Security” light to turn off.
• Press and hold the “Unlock” button on the new remote for 10 seconds.
• Release the button and the “Security” light should flash.
• Repeat steps 7-8 three more times.

Troubleshooting

• If the “Security” light does not flash after resetting the module, try disconnecting and reconnecting the module multiple times.
• If you are unable to reset the module, you may need to visit a Ford dealership for assistance.

Key Points

Resetting your Ford Flex keyless entry without the factory code is a relatively simple process that can be completed in a few minutes. By following these steps carefully, you can regain access to your vehicle and avoid the hassle of replacing the entire system.

Popular Questions

Q: Can I reset my keyless entry without removing the steering column cover?

A: No, removing the steering column cover is necessary to access the keyless entry module.

Q: What if I don’t have a new keyless entry remote?

A: You can still reset the module without a new remote. However, you will need to program a new remote to your vehicle once the module is reset.

Q: Can I use this method to reset other Ford models?

A: This method may work on other Ford models with similar keyless entry systems. However, it is always best to consult your vehicle’s owner’s manual for specific instructions.