Suzuki intruder 800 won’t start? here’s the fix you’ve been missing
What To Know
- If you hear a clicking sound, it could indicate a faulty starter motor or a problem with the starter solenoid.
- The ignition switch sends a signal to the starter motor to crank the engine.
- If the ignition switch is faulty, it may not send the signal, preventing the engine from starting.
The Suzuki Intruder VS800 is a popular cruiser motorcycle known for its reliability. However, like any other vehicle, it can experience occasional starting issues. If your Suzuki Intruder VS800 won’t start, there are several potential causes and troubleshooting steps you can take to resolve the problem.
Check the Battery
A weak or dead battery is a common cause of starting problems. Use a multimeter to measure the battery voltage. A fully charged battery should read around 12.6 volts. If the voltage is below 12 volts, the battery may need to be replaced.
Inspect the Starter Motor
The starter motor is responsible for turning over the engine. Listen for a clicking sound when you turn the key. If you hear a clicking sound, it could indicate a faulty starter motor or a problem with the starter solenoid.
Check the Fuel System
Ensure that there is fuel in the tank. If the fuel tank is empty, fill it up and try again. Inspect the fuel lines for leaks or blockages. A clogged fuel filter can also prevent the engine from starting.
Examine the Spark Plugs
Spark plugs ignite the fuel-air mixture in the engine. Remove the spark plugs and inspect them for wear or damage. Replace any faulty spark plugs.
Check the Ignition Switch
The ignition switch sends a signal to the starter motor to crank the engine. If the ignition switch is faulty, it may not send the signal, preventing the engine from starting.
Inspect the Electrical System
Loose or broken electrical connections can cause starting problems. Check all electrical connections, including the battery terminals, starter solenoid, and ignition switch. Make sure they are clean and tight.
Reset the ECM (Electronic Control Module)
The ECM controls various functions in the motorcycle, including fuel injection and ignition. If the ECM experiences a glitch, it can prevent the engine from starting. Resetting the ECM may resolve the issue.
In a nutshell: Troubleshooting Success
By following these troubleshooting steps, you can identify and resolve the issue preventing your Suzuki Intruder VS800 from starting. Remember to approach the problem systematically and check each component thoroughly. If the problem persists or you encounter any difficulties, seek assistance from a qualified mechanic.
Frequently Discussed Topics
Q: Why won’t my Suzuki Intruder VS800 start after replacing the battery?
A: Ensure that the battery terminals are properly connected and that the battery is fully charged.
Q: How do I know if the starter motor is faulty?
A: Listen for a clicking sound when you turn the key. If you hear a clicking sound, it could indicate a faulty starter motor.
Q: What are the symptoms of a clogged fuel filter?
A: Difficulty starting, engine hesitation, or loss of power while riding.
Q: How often should I replace the spark plugs in my Suzuki Intruder VS800?
A: Refer to your motorcycle’s service manual for the recommended spark plug replacement interval.
Q: Can I reset the ECM on my Suzuki Intruder VS800 myself?
A: Yes, you can reset the ECM by disconnecting the battery for a few minutes. However, it’s recommended to consult your motorcycle’s service manual for the specific instructions.